2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 246Get this manual

2009 Polaris Scrambler 500 4x4 2x4 factory service manual, Page 246

ELECTRICAL HEADLIGHT ADJUSTMENT The headlight beam can be adjusted up and down1Place the vehicle on level surface with the
insert bulb into back of housingTurn 90 to lock into placeThe harness connector should be pointing down 2 (5.1 cm) Below
lamp center height TAILLIGHTBRAKELIGHT LAMP REPLACEMENT 5Loosen nut and bolt securing lamp to handlebars6Adjust beam to desired
position7Tighten nut and boltIf the taillightbrakelight does not work, the lamp may need to be replaced HEADLIGHT LAMP REPLACEMENT
NOTE:Do not touch halogen lamp with bare fingersOil from your skin leaves residue, causing hot spot which will shorten the
life of the lampHold the bulb by the base only1Grasp base of bulb at back of housing and turnCarefully remove bulb from housingBulb
Lens Cover 1From the rear of the taillight remove two screws holding lens cover in place and remove lens cover2Test the taillightbrakelight