2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 68Get this manual

2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 68

ELECTRONIC FUEL INJECTION Primary Test Ignition Coil and HT Lead Replacement NOTE: The plug caps or coil ends are not removableThe
remove the screw retaining the ignition coil to the airboxRemove the coil assembly and disconnect the high tension leads
by pulling on the coil side end capsInstall the new high tension leads Measure Between Connector Pins2,0.4 Secondary Test
NOTE: Be sure to install the PTO (long) wire on the coil terminal nearest the airbox89Install the coil assembly and securely
tighten the mounting screwUpon assembly, make sure the high tension leads are retained by the airbox Measure Between End