2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 180Get this manual

2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 180

CLUTCHING (PVT) 4Install the cover and torque the inner PVT cover screws to specification13Replace the outer PVT cover seal14Reinstall
17Install the left rear wheel and torque wheel nuts to specification Driven Clutch Retaining Bolt: 13 ftlbs(18 Nm) 9Clean
end of taper on crankshaft and the taper bore inside drive clutch using tapered reamer Wheel Nuts: Steel: 45 ftlbs(61 Nm)
Aluminum: 75 ftlbs(102 Nm) 18Lower the ATV, start the engine, and test the operation of the PVT system 10Install the drive
clutch, bushing, washer, lock washer, and the left-hand threaded retaining boltTorque retaining bolt to specification Drive
Clutch Retaining Bolt: 47 ftlbs(64 Nm) 11Install drive belt noting direction of rotation if the belt is being reused (see
"DRIVE BELTBelt Installation", steps 1-3)12Install the PVT outlet ductAlign the duct with the inner PVT cover properly before