2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 211Get this manual

2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 211

FINAL DRIVE FRONT PROPSHAFT Removal 12Locate the front propshaft roll pin through the right front wheel wellPosition the
transmission output shaftTransmission Input Shaft NOTE: If yoke or bearing is removed, cross bearing must be replacedNote
orientation of grease fitting and mark inner and outer yoke for correct repositioning during installation2Support inner yoke
as shown and drive outer yoke down (bearing cap out) with soft face hammer Propshaft Installation 1Apply anti-seize compound
to all splinesSlide propshaft back onto the transmission output shaft, then slide it up onto the front gearcase input shaft,
verify pin holes are alignedUsing Roll Pin Tool (PN 2872608), install NEW roll pin (spring pin) into the propshaftReinstall