2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 245Get this manual

2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 245

FINAL DRIVE Gearcase Installation 123Install the coupler onto the pinion shaft splinesInstall the locking washer(s) and retaining
the rear propshaft and torque bolts to specification Gearcase Mounting Fasteners: 40 ftlbs(54 Nm) 6Install the right rear
drive shaft and the upper A-arm onto the bearing carrierTorque through-bolt fastener to specification Rear Propshaft Bolts:
18 ftlbs(24 Nm) 13Reassemble the PVT system (see Chapter "PVT SYSTEM SERVICEAssembly")14Install the rear wheels and torque
wheel nuts to specification (see Page 8.2)15Add Polaris ATV Angle Drive Fluid to rear gearcase (see Chapter 2)Torque drain
and fill plugs to specification Rear Upper A-arm to Bearing Carrier: 40 ftlbs(54 Nm) 7Install the cone washers (dome facing
retaining nut) and right rear hub retaining nutTorque to specification and install new cotter pin Rear Hub Retaining Nut:
80 ftlbs(108 Nm) 8Install the left rear drive shaft and suspension assemblyTorque the upper and lower A-arms to specification=Rear