2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 248Get this manual

2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 248

BODYFRAME TORQUE SPECIFICATIONS ITEM Upper RH Frame Support Lower LH Frame Support TORQUE VALUE ft.lbs(Nm) 30 ftlbs(41 Nm)
from the vehicle before flame treatingThe side panels, front and rear fender cabs are plastic polyethylene materialTherefore,
they must be "flame treated" prior to installing decal to ensure good adhesionA bonus of the flame treating procedure is
it can be used to reduce or eliminate the whitish stress marks that are sometimes left after fender or cab is bent, flexed,
or damagedTo flame treat the decal area: 1Pass the flame of propane torch back and forth quickly over the area where the
decal is to be applied until the surface appears slightly glossyThis should occur after just few seconds of flame treatingDo
not hold the torch too close to the surface (2-3 inches from the flame tip is recommended)Keep the torch moving to prevent