2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 259Get this manual

2009 Polaris Sportsman 850 XP EFI EPS Service Manual, Page 259

STEERINGSUSPENSION Installation 1Locate the the alignment pin on the bottom side of the upper blockThe pin should line up
the pin side (front) bolts firstTorque the (2) front bolts to specification Carefully remove the handlebar assembly from
the steering post and place it on the front cab IMPORTANT: Take care not to bend the throttle cable or brake line while the
handlebar is removed5Remove the cotter pin and nut from each tie rod end at the steering post frog Handlebar Bolts: 14 ftlbs(19
Nm) 4Install the rear bolts and tighten evenlyTorque the (2) rear bolts to specification Cotter Pin Nut NOTE: There will
be slight gap on the backside of the handlebar blocks after installation5If handlebar was replaced: Install the hand grips