2010 Polaris Sportsman 850 Service Manual, Page 69Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 69

ELECTRONIC FUEL INJECTION 7TPS Output Reading .700 .050 Vdc 9If the voltage does not read within the specification, proceed
the hose clamp retaining the intake boot to the intake plenumRemove the (4) bolts retaining the intake plenum and throttle
bodyPosition the throttle body to access the TPS screwsMake sure the TPS Tester harness is still connected to the TPS harnessLoosen
the TPS mounting screws9 10Reinstall the throttle body and intake plenumTorque bolts to specification 6Rotate the TPS until
your voltmeter reads within the specification (see Figure 3-20)TPS Output Reading .700 .050 Vdc Intake Plenum Bolts: ftlbs(10
Nm) 11Install intake boot to intake plenum and securely tighten the hose clamp12Reinstall the left-hand side panel and seat13Start