2010 Polaris Sportsman 850 Service Manual, Page 122Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 122

ENGINE 24Remove the (2) through-bolt fasteners retaining the LH engine isolator mount to the engine and remove the lower
and IAC as an assembly with the throttle cable still attached to the throttle bodyNOTE: Do not allow throttle body to hang
from the throttle cable29Set the assembly on top of the front cab supportInsert clean shop towel into each intake track of
the engine to prevent debris from entering30Disconnect the fuel injectors at the fuel rail and disconnect the engine coolant
temperature sensor located below the thermostat housing on the left side of the engine31Disconnect and remove the T-MAP sensor
from the intake track to prevent damage upon engine removal32Remove the single spade wire (whitered) and battery cable from