2010 Polaris Sportsman 850 Service Manual, Page 187Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 187

CLUTCHING (PVT) PVT Assembly (TOURING Models) 1Inspect the inner PVT coverReplace if cracked or damagedThe mating surface
tapered reamer3 10Install the drive clutch, bushing, washer, lock washer, and the left-hand threaded retaining boltTorque
retaining bolt to specification Drive Clutch Retaining Bolt: 47 ftlbs(64 Nm) 11Install the PVT outlet ductAlign the duct
with the inner PVT cover properly before tightening the hose clampsImage used as reference Tighten Clamps Install the cover
and torque the inner PVT cover screws to specification Inner PVT Cover Screws: 6-8 ftlbs(8-11 Nm) 567Wipe away any excess
silicone sealantClean the splines inside the driven clutch and on the transmission input shaftApply light film of grease
to the splines on the shaft 12Install drive belt, outer PVT cover and rear skid plateRefer to "Belt Installation (TOURING
Models)"13Reinstall the rear cab, tail light bulbs, and fasteners14Install the seats, start the engine and test the operation