2010 Polaris Sportsman 850 Service Manual, Page 190Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 190

CLUTCHING (PVT) Belt Inspection 1Inspect belt for hour glassing (extreme circular wear in at least one spot and on both sides
the driven sheaves NOTE: Be sure to install the drive belt as shown, so the "Polaris" label can be read NOTE: Be sure to
install the drive belt as shown, so the "Polaris" label can be read POLARIS Rotate the driven sheave and walk the belt into
the clutchReplace the outer PVT cover sealReinstall outer PVT cover and secure with screwsTorque screws to specification
Rotate the driven sheave and walk the belt into the clutchReplace the outer PVT cover sealReinstall outer PVT cover and secure
with screwsTorque screws to specification Outer PVT Cover Screws: 45-50 inlbs(5-5.6 Nm) 56Reinstall the rear skid plate and
the (6) T40 Torx-headed screwsInstall the seat, start the engine and test the operation of the PVT system Outer PVT Cover
Screws: 45-50 inlbs(5-5.6 Nm) 5Reinstall the lower left-hand frame support and torque bolts to specification PVT Break-In
(Drive BeltClutches) A proper break-in of the clutches and drive belt will ensure longer life and better performanceBreak