2010 Polaris Sportsman 850 Service Manual, Page 219Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 219

FINAL DRIVE FRONT PROPSHAFT Removal 12Locate the front propshaft roll pin through the right front wheel wellPosition the
it from the transmission output shaftTransmission Input Shaft NOTE: If yoke or bearing is removed, cross bearing must be
replacedNote orientation of grease fitting and mark inner and outer yoke for correct repositioning during installation2Support
inner yoke as shown and drive outer yoke down (bearing cap out) with soft face hammer Propshaft Installation 1Apply anti-seize
compound to all splinesSlide propshaft back onto the transmission output shaft, then slide it up onto the front gearcase
input shaft, verify pin holes are alignedUsing Roll Pin Tool (PN 2872608), install NEW roll pin (spring pin) into the propshaftReinstall