2010 Polaris Sportsman 850 Service Manual, Page 234Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 234

FINAL DRIVE Setting Ring Gear Backlash NOTE: Ring gear backlash is set at the factoryNo adjustment is required, unless the
18 turn and perform step againRepeat this procedure until the pinion shaft rotates smoothly times (1 revolution of ring gear)
Gearcase Installation (Non-EPS Models) 2Using an Allen wrench, turn the backlash screw out 3-4 turnsRe-apply Loctite 262
onto the bottom screw threads1Install the gearcase between the A-arms as shown 23Turn the screw in until it is lightly seated,
then turn the screw out 14 turn Route the ADC reservoir and clear hose up through the center of the chassisDo not allow hose