2010 Polaris Sportsman 850 Service Manual, Page 248Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 248

FINAL DRIVE 19Install and tighten the large clamp using the Axle Boot Clamp Tool (PU-48951) or CV Boot Clamp Pliers (8700226)
the air pressure to equalize in the CV boot in the position that the joint will spend most of its lifeBefore you remove your
instrument, be sure the small end of the boot is in its correct location on the shaft21Install and tighten the small clamp
on the boot using the Axle Boot Clamp Tool (PU-48951) or CV Boot Clamp Pliers (8700226)Remove the large end of the boot from
the plunging joint and slide the boot down the shaft Clean the grease from the face of the jointPlace the drive shaft in