2010 Polaris Sportsman 850 Service Manual, Page 249Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 249

FINAL DRIVE IMPORTANT: Tap on inner race only! 6Make sure the circlip is still on the shaft and not left in the jointCirclip
of the plunging joint is NOT recommendedThe internal components are precision fit and develop their own characteristic wear
patternsIntermixing the internal components could result in looseness, binding, andor premature failure of the jointIMPORTANT:
If the grease in the joint is obviously contaminated with water andor dirt, the joint should be replaced Boot Replacement
Grease Requirements: Grease Only Service Kits PN 135005920gPN 135004630gPN 135004750g Inner Plunging Joint Capacity: Front60gRear90g
14Fully compress the joint and push the drive shaft firmly into the inner race15Align the circlip with the lead-in chamferThoroughly
clean the joint with an appropriate solvent and dry the joint to prevent any residual solvent from being left in the joint
upon reassemblyVisually inspect the joint for damageReplace if needed10Clean the splines on the end of the shaft and apply