2010 Polaris Sportsman 850 Service Manual, Page 258Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 258

FINAL DRIVE 11Support the gearcase cover and carefully press in the new cover bearing (see Figure 8-28)Support the ring gear
the retaining ring with the straight edge facing the bearing Thoroughly clean the gearcase mating surfaces and be sure the
alignment pins are in placeApply Crankcase Sealant (PN 2871557) to mating surfacesInstall the gearcase cover onto the main
gearcase halfInstall the cover screws and torque to specification 14Install the seal into the main gearcase half using standard
seal installer or other suitable methodPress seal into the gearcase until it bottoms out in the housing Cover Screws: 15-20
ftlbs(20-27 Nm) 8Proceed to "Gearcase Installation" before installing the coupler, lock washer and retaining nutDoing so