2010 Polaris Sportsman 850 Service Manual, Page 264Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 264

BODYFRAME TORQUE SPECIFICATIONS ITEM Upper RH Frame Support Lower LH Frame Support TORQUE VALUE ftlbs(Nm) 30 ftlbs(41 Nm)
the component from the vehicle before flame treatingThe side panels, front and rear fender cabs are plastic polyethylene
materialTherefore, they must be "flame treated" prior to installing decal to ensure good adhesionA bonus of the flame treating
procedure is it can be used to reduce or eliminate the whitish stress marks that are sometimes left after fender or cab is
bent, flexed, or damaged CAUTION Do not flame treat painted plastic componentsPainted plastic surfaces should only be wiped
clean prior to decal adhesionTo flame treat the decal area: 1Pass the flame of propane torch back and forth quickly over
the area where the decal is to be applied until the surface appears slightly glossyThis should occur after just few seconds
of flame treatingDo not hold the torch too close to the surface (2-3 inches from the flame tip is recommended)Keep the torch