2010 Polaris Sportsman 850 Service Manual, Page 277Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 277

STEERINGSUSPENSION Installation 1Locate the alignment pin on the bottom side of the upper blockThe pin should line up with
(4) boltsEvenly tighten the pin side (front) bolts firstTorque the (2) front bolts to specification Carefully remove the
handlebar assembly from the steering post and place it on the front cab IMPORTANT: Take care not to bend the throttle cable
or brake line while the handlebar is removed5Remove the cotter pin and nut from each tie rod end at the steering post frog
Handlebar Bolts: 14 ftlbs(19 Nm) 4Install the rear bolts and tighten evenlyTorque the (2) rear bolts to specification Cotter
Pin Nut NOTE: There will be slight gap on the backside of the handlebar blocks after installation5If handlebar was replaced: