2010 Polaris Sportsman 850 Service Manual, Page 290Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 290

STEERINGSUSPENSION BALL JOINT SERVICE Removal IMPORTANT: Do not reuse ball joint if it has been removed for any reasonIf
must fit the ball joint housing in the A-armThis will allow the ball joint to be properly pressed out of the A-arm without
damaging the Aarm23Remove the retaining ring from the ball jointA driver must be used for the removal of the ball jointUse
the dimensions below to fabricate or locate the correct size driver to use in the following processDriver Dimensions 1.375
in(3.49 cm) in(7.62 cm) 1.75 in(4.45 cm) Press out of the A-arm in this direction Upper A-arm Shown Place driver HERE to