2010 Polaris Sportsman 850 Service Manual, Page 309Get this manual

2010 Polaris Sportsman 850 Service Manual, Page 309

BRAKES 9Repeat the procedure on the two remaining front calipers4510Add DOT brake fluid to .25".30" (6mm) from the top of
pedal NOTE: Do not release pedal before bleeder screw is tight or air may be drawn into caliper9Repeat procedure until clean
fluid appears in bleeder hose and all air has been purgedAdd fluid as necessary to maintain level in reservoir 10Tighten
bleeder screw securely and remove bleeder hoseTorque the bleeder screw to 47 inlbs(5.3 Nm)11Repeat the procedure on the remaining
rear caliper12Using funnel, add brake fluid to the MAX level mark on the reservoir13Field test machine at low speed before
putting into serviceCheck for proper braking action and lever reserveWith lever firmly applied, lever reserve should be no
less than 1 2", (1.3 cm) from handlebar123Thoroughly clean the fluid reservoir cover before removalRemove the cap and diaphragm
from the reservoir and verify fluid level is at the MAX level markIf changing fluid, remove old fluid from reservoir with