2011 Polaris Ranger RZR ATV Service Manual, Page 30Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 30

MAINTENANCE Engine Oil and Filter Service Always change engine oil and filter at the intervals outlined in the Periodic Maintenance
with film of fresh engine oilCheck to make sure the O-ring is in good condition12Install new filter and turn by hand until
filter gasket contacts the sealing surface, then turn an additional 12 turn13Remove the engine oil dipstick (see "Engine
Oil Level")14Fill the sump with qts(1.9 l) of PS-4 Plus Synthetic Engine Oil (2876244) NOTE: Drain plug is accessed through
the skid plate Crankcase Drain Plug Torque: 16 ftlbs(22 Nm) Oil Filter Torque: Turn by hand until filter gasket contacts
sealing surface, then turn an additional 12 turn Oil Filter Wrench: PU-50105: 2.5" (64 mm) Drain Plug 15Verify the transmission
is still positioned in PARK (P)Oil may be hotDo not allow hot oil to come into contact with skin, as serious burns may result567Place
drain pan beneath engine crankcase and remove the drain plugAllow oil to drain completelyReplace the sealing washer on drain
plug16Start the engine and let it idle for one to two minutes17Stop the engine and inspect for leaks18Re-check the oil level