2011 Polaris Ranger RZR ATV Service Manual, Page 87Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 87

ENGINE 4Measure piston ring to groove clearance by placing the ring in the ring land and measuring with thickness gaugeReplace
Service Specifications" on page 3.8 Piston Ring Installed Gap 1Place each piston ring (A) inside cylinder (B) using piston
to push ring squarely into place as shown NOTE: Do not thread the puller bolts into the flywheel more than 14, or stator
coils may be damaged3Remove starter bendix assembly (A)Note the thrust washers located on both sides of the bendixC B A 4Inspect
the thrust washer for wear or damage and replace if necessaryAfter the bendix is removed, remove the two bolts retaining
the starterTap on the starter assembly (B) with soft faced mallet to loosen the starter from the crankcase Piston Ring Installed
Gap: See "800 EFI Engine Service Specifications" on page 3.8 NOTE: Ring should be installed with the mark facing upward2Measure
installed gap with feeler gauge (C) at both the top and bottom of the cylinderB IMPORTANT: difference in end gap indicates