2011 Polaris Ranger RZR ATV Service Manual, Page 90Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 90

ENGINE 8Use white pen to accent the timing marks on the following gears: camshaft gear (K), crankshaft gear (M), or counterbalance
assembly PU-45497-1 NOTE: Install the Cam Gear Tooth Alignment Tool (PU-45497-2) into the assembly hole counter clockwise
from the timing mark (see page 3.42)10Inspect the cam gear teeth and check to make sure there is spring tension offsetting
the teeth between the two gearsIf there is no tension, check the springs inside of the cam gear assembly 13With white marking
pen, accent the timing mark on the gear that contains the springs 3 Loaded Springs Accent Timing Marks 11The cam gear assembly
contains three loaded springsTo open the cam gear assembly: Place the cam gear on fl surface with the timing mark side facing