2011 Polaris Ranger RZR ATV Service Manual, Page 93Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 93

ENGINE 23Inspect the crankshaft gear (Q) for broken or worn teethIf the crankshaft gear does not need to be replaced, it
of the rotors are installed and mesh with the same edges as previously installed 24Install the two puller bolts (R)Tighten
the puller bolts up so that the bolts are at equal length Mark Rotors R 25Install the Flywheel Puller (PN 2871043) and remove
the crankshaft gear, if needed NOTE: If replacing the old rotors, new replacement rotors will fit into the original oilwater
pump housing28Use feeler gauge to measure the clearance between the two rotorsMeasure the gap between the two rotor tips