2011 Polaris Ranger RZR ATV Service Manual, Page 103Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 103

ENGINE 28Before installing the gearstator housing, replace the seals in the coverInstall new water pump seal (N) into the
stator housing attached to the engineShaft damage will occurNOTE: Install the water pump seal (N) with the seal lip facing
out (towards the crankcase)Use of hydraulic press is recommended for this procedure29Install new crankshaft seal (P) into
the gearstator housing coverUse the Universal Driver Handle (PU-45543) and the Main Seal Installer (PA-45483) to seat the
crankshaft seal into placePU-45543 PA-45483 Seal lip goes towards the crankcase30Once the crankshaft seal is installed into
the gearstator housing cover, set the direction of the paper lip by sliding the Main Crankshaft Seal Saver (PA-45658) into
the crankshaft seal from the rubber lipped side to the paper lip side (Back to Front)Remove the toolImportant: Set the direction
of the paper lip seal PU-45658 31Carefully install the tapered end of the Crankshaft Seal Protection Tool (PA-45658) through