2011 Polaris Ranger RZR ATV Service Manual, Page 106Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 106

ENGINE FlywheelStator Installation NOTE: Before assembly, clean the bolts and bolt holes with Primer (PN 2874275) to remove
sequence at the beginning of this chapter96 inlbs(10.85 0.35 Nm) NOTE: Verify stator wires are routed properly under the
wire hold down bracketReplace bolts with new bolts S 96 Stator Housing Bolt Torque: inlbs(10.85 0.35 Nm) Cylinder Head Reassembly
Stator Assembly Bolt Torque: 96 inlbs(10.85 0.35 Nm) 3Install the flywheel, washer, nut, and keyTorque flywheel nut to specification
NOTE: Before reassembly, clean the bolts and bolt holes with Primer (PN 2874275) to remove any debrisThis will ensure proper
sealing when installing bolts1Install the head gasket (A) on the cylinder (B) 65 ftlbs(88 9.50 Nm) 99231422011 RANGER RZRRZRRZR