2011 Polaris Ranger RZR ATV Service Manual, Page 109Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 109

ENGINE 1After the engine is completely assembled and ready for installation, the engine must be properly primed with Polaris
into the oil plug holePush 3-5 oz(approx of Polaris PS-4 PLUS engine oil into the adapter or until resistance is feltRemove
the adapterApply sealant to the plug threadsInstall the plug and torque to specification 40 ftlbs(54 Nm) 28 ftlbs(38 Nm)
PU-45778 Plate is shown detached from transmission for clarity EngineTransmission Mounting Fasteners (2) Lower 38" Nuts:
40 ftlbs(54 Nm) (4) Outer M8 Bolts: 28 ftlbs(38 Nm) 4Install the inner clutch cover, drive clutch, and driven clutchTorque
to specification (see Chapter 6) Clean clutch sheaves thoroughly and inspect inlet and outlet ducts for proper routing and
sealing5To install engine assembly, reverse the "Engine Removal" procedure detailed earlier in this Chapter Properly route
all electrical harnesses for engine assembly installationCheck for any possible rubbing points of electrical wires Carefully
set the engine asse bly into the vehicle while installing the propshaft Primer Plug Torque 18 ftlbs(24.4 2.71 Nm) 99231422011