2011 Polaris Ranger RZR ATV Service Manual, Page 110Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 110

ENGINE Install enginetransmissionrear gearcase mounting hardware and torque to specification Engine Break-In Period The break-in
or sustained high speedPerform regular checks on fluid levels, controls and all important bolt torquesPull only light loads
during initial break-inChange oil and oil filter after break-in period at 25 hours 17 ftlbs(23 Nm) 17 ftlbs(23 Nm) NOTE:
If isolator mounts were removed or replaced, use the following illustration to ensure proper orientation during installationMount
Protrusion Front Isolator Mounts The protrusion of the mount must face inward towards the engineRear Isolator Mounts The
protrusion of the mount must face the RH side of the vehicle 67=Capacity: Approximately U.SQuarts (1.9 L) Oil Type: Polaris
PS-4 PLUS Synthetic Filter Wrench: PU-501052.5" (64 mm)Oil Pressure Specification 27-35 psi 6000 RPM, Polaris PS-4 PLUS Synthetic,
Engine at operating temperature Install rear seat base asse mbly and torque the mounting bolts to 40 ftlbs(54 Nm) Replace
exhaust gasketsS connections with high eal temp silicone sealantCheck to be sure all exhaust springs are in good condition