2011 Polaris Ranger RZR ATV Service Manual, Page 132Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 132

ELECTRONIC FUEL INJECTION Fuel Pump Test If fuel delivery problem is suspected, make certain the fuel pump filters are not
vehicleCover the fuel line connection at the fuel tank with shop towel and disconnect the line from the fuel pump outletInstall
the Fuel Pressure Gauge Adaptor (PV-48656) in-line between the fuel pump outlet and fuel lineConnect the hose from the Fuel
Pressure Gauge Kit (PU43506-A) to the test valve on the Fuel Pressure Gauge Adaptor (PV-48656)Route the clear hose into portable
gasoline container or the vehicle's fuel tank NOTE: If the voltage was below VDC, test the battery, ignition switch, relay(s),
wiring harness and ECU7If the reading is between and 14 volts, turn key switch off and connect an ohmmeter between terminals
"3" and "4"' at the white fuel pump connector to check for continuity within the fuel pump NOTE: If there was no continuity
between the pump terminals, replace the fuel pump assemblyPU-43506-A 8If voltage at the plug was within the specified range,