2011 Polaris Ranger RZR ATV Service Manual, Page 142Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 142

ELECTRONIC FUEL INJECTION THROTTLE POSITION SENSOR (TPS) Operation Overview The throttle position sensor (TPS) is used to
reading at the following pin locations of the TPS: TPS Connector TPS Resistance Readings Pins -GND TPS Throttle Position
Closed Open 4k 11505k1250 4k (reference) (reference) 6k Resistance TPS TesterRegulator Stop Screw (Factory Calibrated) DO
NOT ADJUST The TPS reading can be checked by using the Throttle Position Sensor (TPS) Tester (2201519-A)Set-up the TPS Tester
Wire Harness (PU-47466) and TPS Tester Regulator (547927) according to the instructions that accompanied the testerMake sure
the Volt battery is new The correct position of the throttle body stop screw is established and set at the factoryDO NOT
loosen the throttle body stop screw or alter its position in any mannerThe stop screw controls the air flow calibration of