2011 Polaris Ranger RZR ATV Service Manual, Page 143Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 143

ELECTRONIC FUEL INJECTION Verify TPS Tester Reference Voltage volt reference voltage from the TPS Tester harness is required
the seats, rear service panel and the rear cargo box (see Chapter 5)Loosen the hose clamps retaining the throttle bodyRemove
the throttle body from the intake track and plug the intake boots with clean shop towel NOTE: If just setting TPS voltage,
loosen the throttle body hose clamps and rotate the throttle body to allow access to the mounting screws45Disconnect the
vehicle harness from the TPSRemove the (2) Phillips-head mounting screws and replace the TPS TPS Reference Voltage Vdc Input
IMPORTANT: Always use fresh Volt battery IMPORTANT: If replacing the TPS or throttle body, you must set the TPS voltage to
specification using the TPS Tester or Digital WrenchTM Sensor Data Display6If Digital WrenchTM in unavailable, assemble the