2011 Polaris Ranger RZR ATV Service Manual, Page 147Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 147

ELECTRONIC FUEL INJECTION IGNITION COIL Operation Overview The ignition coil is used to provide high voltage to fire the
table to test the ignition coil resistance Ignition Coil Resistance Readings Test Primary Secondary Primary Test Measure
Between Connector Pins 0.4 Pin Connection BetweenBetweenBetween High Tension Lead End Caps Resistance 0.4 6.7k 5 Ignition
Coil Ignition CoilHT Lead Replacement NOTE: Mark or note which ignition coil wire goes to which cylinder and ignition coil
postThe engine will misfire if the spark plug wires are installed incorrectlyThe spark plug wires are marked with PTO and
MAG from the factory and should be installed to the corresponding cylinder and ignition coil post123Remove the rear service
panel to access the ignition coilDisconnect the ignition coil harness and remove the high tension leads from the coilRemove
the fastener retaining the ignition coil and remove it from the vehicleIf replacing the high tension lead(s), remove the