2011 Polaris Ranger RZR ATV Service Manual, Page 165Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 165

BODYSTEERINGSUSPENSION CAB FRAME (RZR 4) AssemblyRemoval NOTE: Finger tighten all components until cab frame is completely
net over front coupler post on front cab frameFasten the front of the cab frame to the base brackets and mid cab frame using
the (38-16 14) bolts and (38-16 Nyloc) nutsTighten bolts to 25-28 ftlbs(34-38 Nm)Fasten mid cab frame brackets to the vehicle
with (516-18 1) bolts and (516-18 Nyloc) nutsTighten bolts to 16-18 ftlbs(22-24 Nm)Fasten (516-18 34) tap screws to the outsides
of each bracketTighten tap screws to 15 ftlbs(20 Nm)Fasten side bars by sliding the lower portion into the U-shaped bracket
on the mid cab frameFasten the upper portion to the rear cab frame using (14-20 34) Phillips-head screws and (14-20 Nyloc)
nutsTighten screws to 6-8 ftlbs(8-11 Nm)Fasten (14-20 34) Torx-head screws into lower portion of side bars through bracket