2011 Polaris Ranger RZR ATV Service Manual, Page 184Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 184

BODYSTEERINGSUSPENSION Steering Shaft Bearing Replacement IMPORTANT: Replacement pivot tube assembly comes with new upper
portion of the steering shaft onto the steering gear box assembly (see Figure 5-16)Torque the lower pinch bolt to 30 ftlbs(41
Nm)12Install the (2) fasteners that retain the pivot tube (see Figure 5-17)Torque fasteners to 23 ftlbs(31 Nm)13Install the
fastener retaining the upper portion of the steering wheel tilt shock to the pivot tube (see Figure 5-17)Torque fastener
to ftlbs(10 Nm)14Be sure the front wheels are facing straight forwardRemove the steering wheel and align as neededTorque
the steering wheel nut to 28 ftlbs(38 Nm)15Wipe the pivot tube clean of any excess Loctite16Install steering wheel cap and
field test steering operation NOTE: Use care not to allow any of the Loctite to get in the bearingThick Washer Spacer Pivot
Tube Cap Nut Thin Washer Bearing Spacer Thick Washers Bearing Thin Washers NOTE: Be sure the lower washers and spacers are
still on the steering shaft8Apply Loctite 271TM (Red) to the outer circumference of the new upper bearing raceSlide the new