2011 Polaris Ranger RZR ATV Service Manual, Page 191Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 191

BODYSTEERINGSUSPENSION FRONT A-ARMS RemovalReplacement The following procedure details upper and lower A-arm removal and
new lower A-arm assembly onto vehicle frameTorque new bolt to specification22Insert lower A-arm ball joint end into the bearing
carrierInstall lower ball joint pinch bolt (E) into the bearing carrier and torque bolt to specification Upon A-arm installation
completion, test vehicle at low speeds before putting into service Front UpperLower A-arm Bolts: RZR: 37 ftlbs(50 Nm) RZRRZR
4: 40 ftlbs(54 Nm) The locking agent on the existing bolts was destroyed during removalDO NOT reuse old hardwareSerious injury
or death could result if fasteners come loose during operation89If not replacing the A-arm, thoroughly clean the A-arm and
pivot tubeInstall new ball joint into A-armRefer to "Ball Joint Replacement" section Front Ball Joint Pinch Bolts: 23 ftlbs(31
Nm) Shock Mounting Bolts: RZR: 30 ftlbs(41 Nm) RZRRZR 4: 37 ftlbs(50 Nm) 10Insert new A-arm bushings and pivot tube into
new A-arm11Install new upper A-arm assembly onto vehicle frameTorque new bolt to specification12Insert upper A-arm ball joint