2011 Polaris Ranger RZR ATV Service Manual, Page 193Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 193

BODYSTEERINGSUSPENSION BALL JOINT SERVICE Removal IMPORTANT: Do not reuse ball joint if it has been removed for any reasonIf
will allow the ball joint to be properly pressed out of the A-arm without damaging the AarmPress out of the A-arm in this
direction Remove the retaining ring from the ball jointA driver must be used for the removal of the ball jointUse the dimensions
below to fabricate or locate the correct size driver to use in the following processDriver Dimensions 1.375 in(3.49 cm) in(7.62
cm) 1.75 in(4.45 cm) Upper A-Arm Shown Place driver HERE to support A-arm - Outside diameter of driver cannot be any larger