2011 Polaris Ranger RZR ATV Service Manual, Page 194Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 194

BODYSTEERINGSUSPENSION Installation 1Place the A-arm in the correct position for ball joint installationFace the A-arm end
assembly if damagedReverse the procedure for installationTorque the linkage fasteners to specification (see "Exploded View")Place
driver HERE to support A-arm Upper A-Arm Shown 45After the new ball joint is installed into the A-arm, install NEW retaining
ring Stabilizer Bar Removal 1If stabilizer bar linkages are installed, remove the bolts that attach the upper portion of
the linkages to the sway bar clamps (see "Exploded View")Remove the front bumper (see "BODY COMPONENT REMOVALFront Bumper")Remove
the (4) T30 Torx fasteners retaining the front bumper support to the frameMain Frame T30 Screws Nuts Ball Joint Upper A-arm
NEW Retaining Ring Standard RZR Shown Reinstall the A-arm (see "FRONT A-ARMSRemovalReplacement")Repeat the ball joint service