2011 Polaris Ranger RZR ATV Service Manual, Page 197Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 197

BODYSTEERINGSUSPENSION 67If not replacing the A-arm, thoroughly clean the A-arm and pivot tubesInsert new A-arm bushings
fastener to specificationInstall wheel and torque wheel nuts to specification5 2Remove the fastener (G) retaining the lower
portion of the shock to the lower A-armUpon A-arm installation completion, test vehicle at low speeds before putting into
service J Rear UpperLower A-arm Bolts: RZR: 33 ftlbs(45 Nm) RZRRZR 4: 40 ftlbs(54 Nm) G Lower Rear Bearing Carrier Bolts:
RZR: 38 ftlbs(52 Nm) RZRRZR 4: 40 ftlbs(54 Nm) H 34Remove the fastener (H) attaching the lower A-arm to the bearing carrier
(see previous illustration)Remove the (2) fasteners (J) attaching the lower A-arm to the frame and remove the lower A-arm
from the vehicle (see previous illustration)Examine bushings and pivot tubes (see "Exploded View")Replace if wornDiscard
hardwareShock Mounting Bolts: RZR: 30 ftlbs(41 Nm) RZRRZR 4: 37 ftlbs(50 Nm) Upper Rear Bearing Carrier Bolts: RZR: 33 ftlbs(45