2011 Polaris Ranger RZR ATV Service Manual, Page 201Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 201

BODYSTEERINGSUSPENSION DECAL REPLACEMENT The following procedure involves the use of an open flamePerform this procedure
the whitish stress marks that are sometimes left after fender or cab is bent, flexed, or damaged Do not flame treat painted
plastic componentsPainted plastic surfaces should only be wiped clean prior to decal adhesionTo flame treat the decal area:
1Pass the flame of propane torch back and forth quickly over the area where the decal is to be applied until the surface
appears slightly glossyThis should occur after just few seconds of flame treatingDo not hold the torch too close to the surface
(2-3 inches from the flame tip is recommended)Keep the torch moving to prevent damageApply the decal on one edge firstSlowly
lay down remainder of the decal while rubbing lightly over the decal surface to eliminate any air bubbles during the application