2011 Polaris Ranger RZR ATV Service Manual, Page 210Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 210

BODYSTEERINGSUSPENSION Figure Figure 9 24Slide bearing assembly off of shaftUse extreme caution not to scratch inside of
seating of O-ring, use the nonwriting end of pen, or similar soft, blunt object, to push it inInstall the new U-cup seal
into bearingU-cup should be installed so the cupped end is facing the DU bushing inside of bearingCheck to make sure seal
is properly seatedIf tool is required to aid in proper seating of U-cup seal, use the non-writing end of pen, or similar
soft, blunt object, to push it in (Fig10) FOXTM Shock Rebuild 1Use scribe or dental pick to remove the U-cup wiper (Fig8)
and O-ring seals (Fig9) from the bearing housingBe careful not to scratch the seal grooves or the DU bushing that is pressed
into the bearingFigure 8 345IMPORTANT: Use extreme caution when using scribe to remove sealsAlways "spear" the seal with
the point of the scribeDo not wedge the point of the scribe in behind the sealThis can scratch the surface of the seal groove