2011 Polaris Ranger RZR ATV Service Manual, Page 211Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 211

BODYSTEERINGSUSPENSION 7Install the scraper in the bearing housingCheck for proper orientation of the scraper in the bearingThe
of assembly lubeSlide the bearing assembly onto shaft with the scraper facing the eyelet (Fig11)This should be done in single
smooth motion to avoid damaging the sealsFigure 11 Polaris Gas Shock OilwtPN 2870995qtPN 28722792.5 gal9Push the IFP into
the reservoir until you have enough oil on top of the IFP so that the bleed hole is under the surface of the oil (Fig12)Figure
12 Insert the shaft of Phillips head screwdriver through the center of the piston assemblyThe pointed end of the screwdriver
should be on the same side as the top-out plateCut and remove the tie wrap that was holding the piston assembly togetherHold
the piston assembly from underneath the top-out plate and place the end of the screwdriver onto the end of the shock shaftSlide
the piston assembly onto the shaft endCheck to make sure the piston assembly is properly seated, then install the piston