2011 Polaris Ranger RZR ATV Service Manual, Page 212Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 212

BODYSTEERINGSUSPENSION 12Fill shock body to the bottom of bearing threads with oil13Using the IFP Depth Setting Tool, slowly
this process several times until you don't see any new bubbles inside the body tube15Pull the IFP up until it's top is approximately
1" from the end of the reservoir and remove the IFP depth setting toolAgain, be sure the oil level in the shock body does
not drop below the bottom of the bodyIf the oil does recede completely from the body, you must remove the IFP and go back
to step of reassemblyAdd oil if necessary while pulling up on the IFP16Using the flat blade screwdriver, turn the Compression
Adjuster Screw clockwise until it stops turning17Fill the body tube with oil approximately 14" below the threadsWrap the
new piston band around the piston, making sure the rounded edges face outInsert the shaft assembly into the body tubeSlowly
push shaft into body until piston assembly is approximately 1" below oil surface18Stroke the shaft up and down slowly over
about 1" range until no air bubble rise from the damping pistonBe careful to keep the damping piston at least 14" below the