2011 Polaris Ranger RZR ATV Service Manual, Page 222Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 222

BODYSTEERINGSUSPENSION 25Install the reservoir capPush down on the reservoir cap using even pressure until the retaining
valve cap32Clean all oil residue from the shock and reservoir with solvent, and dry with low pressure compressed air in well
ventilated area33Check shock for any leaks34Reinstall the compression spring and the spring retainer PN 2200421 35Thread
the spring preload adjuster down against the spring and set the preload to the specified measurement (see Chapter 2)36Set
the compression adjuster knob to the recommended setting or the original setting upon removal (see Chapter 2)37Remove the
shock from the vise38Reinstall spherical bearing O-rings and polyurethane bushings 30Continue filling until the shaft has
fully extended and the reservoir pressure is at 200 psi NOTE: After installation, be sure to RIDE SLOWLY initially to ensure