2011 Polaris Ranger RZR ATV Service Manual, Page 229Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 229

CLUTCHING 10Install the Drive Clutch Holder (PN 9314177) (A)11Remove drive clutch retaining bolt and remove drive clutch
the inner clutch cover to the engine and transmission456Install and properly align the inner clutch coverInstall the bolts
and washers that retain the cover to the transmissionTorque bolts to specification (see next page)Install the screws that
retain the cover to the engineTorque screws to specification (see next page)Remove any excess silicone sealantInstall clutch
offset washers on the transmission input shaftOffset Washers Clean the splines inside the driven clutch and on the transmission
input shaftApply light film of grease to the splines on the shaft 10Install the driven clutch, washer, lock washer, and retaining