2011 Polaris Ranger RZR ATV Service Manual, Page 230Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 230

CLUTCHING 11Clean end of taper on crankshaft and the taper bore inside drive clutch12Install drive clutch and torque retaining
Offset Procedure" provided below1Follow steps 1-6 of the "PVT Disassembly" procedure Do not start the engine with the outer
clutch cover removedSerious injury may result2Inspect the drive clutch belt to sheave clearanceIf the belt is contacting
either sheave, remove the drive belt and driven clutch Inner Cover Bolt Torque (Rear): 12 ftlbs(16.6 Nm) Outer Cover Bolt
Torque: 45-50 inlbs(5-5.6 Nm) Driven Clutch Retaining Bolt Torque: 17 ftlbs(23.5 Nm) Drive Clutch Retaining Bolt Torque:
40 ftlbs(54 Nm) 16Install the clutch cover outlet duct and tighten the clamps Incorrect Offset Add or remove offset washers
behind the driven clutch accordingly to avoid belt contact with either drive clutch sheaveOffset Washers 17Reinstall the