2011 Polaris Ranger RZR ATV Service Manual, Page 240Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 240

CLUTCHING NOTE: Use Bushing Tool PA-47336 Clutch components will be hot! In order to avoid serious burns, wear insulated
Pin Puller (PN 2870386) Main Puller Adaptor (#8) (PN 5020632) Bushing Main Adapter (8) Piston Pin Puller Install puller adapter
(Item 10 from kit PN 2871226)Install main adapter (Item D) onto pullerPuller Tool (A,B) Side "A" toward sheave Nut (C) 34Set
bushing in place on sheaveInsert installation puller tool (Item AB) with "A" side down, into center of bushingNOTE: 800 EFI
ClutchUse Bushing Tool PA-47336With towers pointing upward, slide sheave, bushing and tool onto puller rodInstall nut on
puller rod and hand tightenTurn barrel to apply additional tension if neededTurn sheave counterclockwise, making sure bushing
is drawn straight into boreContinue until bushing is seatedRemove nut from puller rod and set asideRemove sheave from puller2Apply
Loctite 609 evenly to bushing bore inside moveable sheave Puller Adapter (10) Main Adapter (D) 67Piston Pin Puller With towers