2011 Polaris Ranger RZR ATV Service Manual, Page 252Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 252

FINAL DRIVE Bearing Installation 5Thoroughly clean the front bearing carrier housing and the outer race on the new bearingBe
RZR Shown NOTE: Use care to not allow any of the Loctite compound to get in the bearing8Wipe the housing clean of any excess
compound and install the snap ring Ball Joint Pinch Bolts: 23 ftlbs(31 Nm) 45Apply grease to drive shaft axle splinesInstall
front wheel hub assembly, cone washers, and hand tighten the castle nutInstall washers with domed side out Bearing Carrier
Installation 12Install drive shaft axle through the backside of the bearing carrierInstall the upper and lower ball joint
ends into the front bearing carrier Cone Washers Wheel Hub Out 6Install brake caliper mounting bolts and torque to specification