2011 Polaris Ranger RZR ATV Service Manual, Page 257Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 257

FINAL DRIVE 12Grease the joint with the special joint grease provided in the boot replacement kitFill the cavity behind the
the drive shaft firmly into the inner race14Align the circlip with the lead-in chamfer15Use soft-faced hammer to tap the
joint onto the drive shaft until it locks into place16Pull on the joint to make sure it is securely locked into place17Remove
excess grease from the plunging joint's external surfaces and place the excess grease in the boot18Pull the boot over the
joint and position the boot lips into the grooves on the joint housing and shaftMake sure the boot is not dimpled or collapsed19Install
and secure the small clamp on the boot using the "earless" clamp pliersCV Joint Grease Capacity 80 Grams Grease Capacity
80 Grams CV Boot Clamp Pliers Earless Type: 8700226 20Pull out on the drive shaft to center the joint in the housingSlide