2011 Polaris Ranger RZR ATV Service Manual, Page 261Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 261

FINAL DRIVE 9If removing the rear portion of the propshaft, remove the bearing support (upperlower half) from the shaft Support
portions of the propshaft13Torque the support bearing fasteners to specification Remove the rubber isolator from the bearing
and slide the bearing off the end of the shaft Support Bearing 16-18 ftlbs(22-24 Nm) Rubber Isolator NOTE: If bearing is
seized on the shaft, remove the rear portion of the shaft from the vehicleRefer to "RemovalInstallation (RZR 4)"45Clean the
mounting surface of the shaft and install the new bearingInstall new retaining ring and slide the bearing tight against the