2011 Polaris Ranger RZR ATV Service Manual, Page 269Get this manual

2011 Polaris Ranger RZR ATV Service Manual, Page 269

FINAL DRIVE 7Remove the RH output hub assembly from the gearcase housing10Inspect the AWD coil located in the outer cover
care not to allow them to fall out or lose them upon removal of the roll cage12Thoroughly clean all parts and inspect the
rollers (A) for nicks and scratchesThe rollers must slide up and down and in and out freely within the roll cage (B) sliding
surfaces and H-springsC External Snap Ring Replace Seal Bearing Internal Snap Ring Inspect the pinion gear for chipped, broken
or missing teethInspect the pinion bearing for signs of wear and the pinion shaft seal surface for pittingA IMPORTANT: Refer
to the "Electronic Parts Catalog" for individual part availabilityMost parts are to be replaced as an assembly or as complete